Data I/O UniSite-xpi, User Manual

Page: 183 / 413

4. Commands
UniSite-xpi User Manual 4-49
Add This command displays the Add screen. In the Add screen, you can add
new devices to a Custom Menu.
Note: Use the Add command only to add devices to an already created Custom
Menu (a Custom Menu created using the Create or Update command).
To add devices to a Custom Menu, follow these steps:
1. Select Add. The programmer prompts you for the
Source Disk
Algorithm Type (D,E,K)
Algorithm Media (F,M)
—only appears if MSM is installed
Destination Disk
Custom Menu Algorithm Disk
where (D, E, K) is default algorithms, extended algorithms, or Keep
Current algorithms, and (F, M) is floppy disk or Mass Storage
Module (MSM).
2. Select the algorithm media and algorithm source of the device you
wish to add to your Custom Menu. In the Custom Menu algorithm
disk
field, select the disk drive where the Custom Menu is located.
3. If prompted, insert the Algorithm disk that contains the algorithms
from which you want to choose into the disk drive, and press E
NTER
to continue. Follow the directions on the screen (inserting disks if
prompted).
CAUTION: This operation uses RAM as a temporary storage buffer and
alters the contents of RAM.
4. The programmer displays a list of devices (if algorithm type K was
selected in step 2) or a list of device manufacturers (if algorithm type
D
or E was selected in step 2).
Examine the list and select a device or device manufacturer by typing
the number corresponding to the selection and pressing E
NTER
. If the
device or device manufacturer you want is not listed, press C
TRL
+ N
to see the next page of devices or manufacturers.
5. If you selected a manufacturer in step 4, a list of devices produced by
the selected manufacturer appears. Type the number corresponding
to the device you wish to add to your Custom Menu, and press
E
NTER
to add the device. (C
TRL
+ N to see the next page of devices.)
More
Com-
mands Custom
Menu Algs
Add
Configure
System