Data I/O UniSite-xpi, User Manual

Page: 128 / 413

3. Getting Started
3-56 UniSite-xpi User Manual
Inserting To turn on insert mode, press C
TRL
+ T. This will light up the insert
indicator on the bottom of the screen. With this indicator lit, every
character typed will be inserted at the cursor and all following characters
will be pushed to the right.
The third and last correction is adding the word UniSite-xpi before the
period below the word loaded. Move the cursor on top of the period and
type
UniSite- xpi
Restoring Your File
If you are not satisfied with your edits and you want to restore the
current screen of data, press C
TRL
+ U. UniSite-xpi restores the current
screen of data to the state it was in after the last save.
Note: When you move to another block, all edits are saved.
Saving Your Edits
Save your edits if you are satisfied with them. Press F2 to save your edits
and return to the previous menu.
Note: When you exit the Edit screen or move to another block, all edits are saved.
If you are saving to RAM, there is no way to recall the original data file
once you save an edited data file.
Review
In this Session, you learned how to edit a data file stored in RAM. To
access UniSite-xpi’s built-in editor, press M, E, E from the Main Menu.
Then, from the Edit Programmer Memory screen, select R to edit RAM.
Once you are in the editor, you can edit data in either its hex
representation or its ASCII representation. Press T
AB
to toggle between
the two modes.
The editor defaults to overtype mode, but it can also operate in insert
mode. Press C
TRL
+ T to toggle between the two modes.
After making edits to a page of data, you can restore the page to its
original condition by pressing C
TRL
+ U.
Session 20: Programming a Memory Device
This Session shows you how to use UniSite-xpi to program a memory
device.
Before You Begin
Make sure you have completed Session 1, an introduction to the
UniSite-xpi interface.