Identifying Batch Samples
Introduction
Sample Programming
IMMAGE 800 Operations Manual A11403
Page 7-46
September 2016
Identifying Batch Samples
Introduction
After a sample program is entered for a batch, the samples in the batch must be
identified.
The procedure for identifying samples in a batch is different when Bar Code Priority is
enabled in Setup than when Bar Code Priority is disabled.
Identifying Batch Samples, Bar Code Priority Enabled
Follow the steps below to identify which samples are to be included in a batch if bar
code priority is enabled in Setup.
Figure 7.12
Program Batch Screen, Bar Code Priority Enabled
Step
Action
1
Select
Program Batch [F4]
when all information to be applied to the
batch is programmed.
2
Type the Sample ID for each sample in the batch. (Refer to Figure 7.12.)
Rack and Position numbers can be entered for samples that are not bar
coded.
3
Select
End Batch [F10]
when all Sample IDs are entered.
E010263S.EPS
