Date and Time Setup
Changing the Time
System Setup
IMMAGE 800 Operations Manual A11403
Page 5-48
September 2016
Changing the Time
The instrument status must be in
Standby
in order to proceed with the steps below to
change the time.
Figure 5.20
Change Time Dialog Box (24 hour format)
Step
Action
1
From the Setup screen, select
<9> Date/Time
2
Select
Change Time [F3]
3
Correct the hour (displayed above the hh), if needed.
• delete the currently displayed hour
• type the correct hour in its place
The digits for "hour" can be entered with or without a leading zero for
numbers less than ten. For example, "4" or "04" may by entered for four
o’clock.
4
Correct the minute (displayed above the mm) if needed.
• delete the currently displayed minute
• type the correct minute in its place
The digits for "minute" can be entered with or without a leading zero for
numbers less than ten. For example, "4" or "04" may by entered for four
minutes after the hour.
5
If the time format is set to twelve hour mode correct the AM/PM setting, if
necessary.
1. Select the button beside the AM or PM.
2. Select
1
for AM or
2
for PM.
6
Select
<OK>
to save the changes.
OR
Select
<Cancel>
to return to the Date and Time screen without saving the
changes.
E010226S.EPS
