Rexroth Indramat CLM1.4, Manual

Page: 175 / 274

9-12
Interfaces CLM01.4-LAP-01VRS
DOK-CONTRL-CLM01.4LAP1-FK01-EN-P
In preparation
Here, the requirements are mirrored.
These marker flags can only be read by the programs.
In preparation
Here, the CLM conditions are mirrored.
These marker flags can only be read by the programs.
M2.00 - M2.19
These marker flags can be read and written via NC commands. These
marker flags are cleared when exiting Automatic Mode, losing power or
when a fault occurs.
M3.00 - M3.07
These marker flags can be read and written via NC commands. They are
not cleared, even when power is lost.
M4.00 - M4.09
These marker flags are only for signal transfers between the NC Tasks
and the Logic Task. They can be read and written by the NC Tasks. The
Logic Task can only read these marker flags.
These marker flags are cleared when power is lost.
M5.00 - M5.09
These marker flags are only for signal transfers between the Logic Task
and the NC Tasks. They can be read and written by the Logic Task. The
NC Tasks can only read these marker flags.
These marker flags are cleared when exiting Parameter Mode, when a
fault occurs in the Logic Task, or when power is lost.
M6.00 - M6.19
These marker flags can be read and written by the Logic Task. They are
not cleared, even when power is lost.
M6.20 - M6.39
These marker flags can be read and written by the Logic Task. These
marker flags are cleared when exiting Parameter Mode, when a fault
occurs in the Logic Task, or when power is lost.
System Flags (Inputs)
System Flags (Outputs)
NC Marker Flags
Saved NC Marker Flags
Transfer Flags NC
Å
Logic Task
Transfer Flags Logic
Task
Å
NC
Saved Logic Task Marker Flags
Logic Task Marker Flags