Rexroth Indramat CLM1.4, Manual

Page: 38 / 274

CLM01.4-LAP-01VRS Display and Operating Devices
4-9
DOK-CONTRL-CLM01.4LAP1-FK01-EN-P
Display Mode ’Remaining Distance’
R 1 A + 0 0 0 5 0 0 . 0 0 0
E 2 + 0 0 0 0 5 0 . 0 0 0
S 3 + 0 0 0 0 0 0 . 0 0 0
t 4 A + 0 0 0 3 0 0 . 0 0 0
Remaining distance in Input Units (IU)
A = Homed
Axis Number
For Interrupting, Immediate Stop and Positioning Monitoring, the
remaining travel distance is shown. For axes that are not programmed, no
information is shown on the display.
A c t . S p e e d R P M
1 : + 2 0 0 0 2 : + 0 0 0 0
3 : + 3 0 0 0 4 : + 0 0 0 0
Display of the Speed in Rpm
Axis Number
The displayed speed is a message about the last 32 cycles, in order to
keep the contents of the display consistent. Speed values are rounded to
the nearest whole number. For axes that are not programmed, no
information is shown on the display.
Display Mode ’Length’:
Display Mode ’Measuring Wheel Operation, Axis 1’
L M R A + 0 0 0 1 0 0 . 0 0 = Actual Position of the Measuring Wheel
1 + 0 0 0 0 9 9 . 9 6 = Actual Position of Drive, Axis 1
D i f f . + 0 0 0 0 0 0 . 0 4 = Difference between Measuring Wheel and Drive
If a measuring wheel in the system is being monitored by the control, an
additional display appears.
The measuring wheel position display is only active when you are in
Measuring Wheel Mode. If axis 1 is not homed, the displayed position can
be set to zero by pressing
.