Rexroth Indramat CLM1.4, Manual

Page: 218 / 274

CLM01.4-LAP-01VRS Diagnostic Messages
11-5
DOK-CONTRL-CLM01.4LAP1-FK01-EN-P
11.3 Error Descriptions
The following sections describe the error messages that appear on the
CLM display.
General Error Messages
Hex Code 00 = No Error Message
The CLM is in Manual or Automatic Mode.
Hex Code 01 = No Error Message
The CLM is in Parameter Mode.
I s I N V A L I D
Hex Code 02
P a r a m e t e r A 1 0 0
M o d e A 1
This message appears when the value stored in a CLM parameter
exceeds the minimum or maximum limits. The message appears on the
first line of the display; the second line displays the number of the affected
parameter.
1.The parameter containing the invalid input can be displayed by
switching into Parameter mode and pressing the
key on the CLM
keypad, or by pro24 Vdc to the external Clear input (connector X3,
pin 8).
2.Consult chapter parameter for the minimum and maximum limits of the
parameter in which the error occurred.
E R R O R
Hex code 03
E M E R G E N C Y S T O P
The "EMERGENCY STOP" error occurs when +24 Vdc signal to the CLM
Emergency Stop input is interrupted (connector X3, pin 3).
1.The Emergency Stop pushbutton has been pressed.
2.The Emergency Stop circuit has been broken. Consult the machine
builder’s wiring diagrams to determine what could have caused the break
in the E-Stop circuit.
3.+24 Vdc has been applied to CLM connector X5, pins 1 and 2, but CLM
connector X3 is not installed.
4.+24 Vdc must be applied to CLM connector X3, pins 36 and 37. Also,
the reference (0 Vdc) must be applied to the CLM connector X3, pins 34
and 35.