Rexroth Indramat CLM1.4, Manual, Page: 34 / 274

CLM01.4-LAP-01VRS Display and Operating Devices
4-5
DOK-CONTRL-CLM01.4LAP1-FK01-EN-P
After turning on the control or after clearing a fault, the CLM either
displays the software version or ’Parameter Input’ mode is active (see
Operating Mode). The display mode can be changed at any time. In order
to do this, the cursor must be returned to the base position: first line, third
position. This movement can be made by pressing the
and keys, or,
more simply, by pressing . Then the display mode can be changed
using the and keys.
For some display modes, no blinking cursor is shown. In such cases, the
cursor is in its base position but it is not visible.
Software Version / Status Diagnostics
In this display, the user can switch to Status Diagnostics by pressing or
. The diagnostic depends on the operating mode and the status.
C L M 0 1 . 4 - P - E - 4 - B
C L M 1 . 4 - L A P - 0 1 V R S
Software Description
The release version is shown in line 4 by pressing .
S y s t e m I s R e a d y
Control Status: Immediate Stop at +24V
S t o p A c t i v e
Control Status: Immediate Stop at +0V
Operating Mode: Manual