Rexroth Indramat CLM1.4, Manual, Page: 123 / 274

8-6
Parameters CLM01.4-LAP-01VRS
DOK-CONTRL-CLM01.4LAP1-FK01-EN-P
Ax01 Axis x Feed Constant
F e e d C o n s t a n t A x
A x 0 1
0 0 5 0 . 0 0 0 0 0
Feed constant in IU
Note: This is where the IU is defined
IU = Input Unit
This parameter describes the conversion from rotary to linear motion. It is
defined as the linear displacement of the load during one revolution of the
gear drive shaft.
Input can be in any desired dimension (e.g. mm, cm, m, inch, degrees,
etc. and is referred to below as the input unit (IU).
It is important that all other measurements entered be referenced to this
same unit.
The input has five decimal places.
Input range: from 0.01000 to 5000.00000 in IU
Note: For rotary table programming using an incremental encoder,
the unit per table revolution is set in Parameter Ax01, e.g.:
Ax01 = 0360.00000 corresponds to 360
°
per table revolution
The gear ratio is defined in Parameter Ax02.