Rexroth Indramat CLM1.4, Manual

Page: 260 / 274

CLM01.4-LAP-01VRS Installation Notes
13-9
DOK-CONTRL-CLM01.4LAP1-FK01-EN-P
The following is especially to be observed:
•
Keep free and clear of the machine’s range of motion.
⇒
Prevent personnel from accidentally entering the machine’s range of
motion: Use protective fences, protective screens, protective coverings
and light barriers or light curtains.
•
Fences and coverings must be strong enough to withstand maximum
possible momentum.
•
Mount the emergency stop switch (E-stop) within the immediate reach
of the operator. Verify that the emergency stop works before startup.
•
Isolate the drive power connection by means of an emergency stop
circuit or use a start-inhibit system to prevent unintentional start-up.
•
Make sure that the drives are brought to a standstill before accessing
or entering the danger zone.
•
Disconnect electrical power to the equipment using a master switch
and provide safeguards to prevent unintentional restarts when:
- performing maintenance and repair work
- cleaning the equipment
- long periods of discontinued equipment use are imminent
Protection During Handling and Installation
Avoid operating high-frequency and radio equipment near electronic
circuits and supply leads. If use of such equipment cannot be avoided,
the system and the facility in which it is installed should be checked for
possible malfunctions at all possible positions of normal use before the
first start-up. If necessary, perform a special electromagnetic
compatibility (EMC) test on the facility.
Under unfavorable conditions, improper handling and installation of this
equipment may cause injuries.
CAUTION
Error During Handling and Installation
Under unfavorable conditions, inappropriate handling and
installation of this equipment may cause injuries
(crushing, shearing, cutting and mechanical shock).
⇒
Preventive Measures:
•
Observe general instructions and safety regulations
regarding handling and installation.
•
Use only appropriate lifting or moving equipment.
•
Take precautions to avoid pinching and crushing.
•
Use only appropriate tools. If specified by the product
documentation, special tools must be used.
•
Use lifting devices and tools correctly and safely.
•
Wear appropriate protective gear, e.g. safety glasses,
safety shoes and safety gloves.
•
Never linger under suspended loads.
•
Clean up liquids from the floor immediately to prevent
the risk of slipping.