Rexroth Indramat CLM1.4, Manual

Page: 219 / 274

11-6
Diagnostic Messages CLM01.4-LAP-01VRS
DOK-CONTRL-CLM01.4LAP1-FK01-EN-P
E R R O R
Hex Code 04
B a t t e r y i s l o w !
⇒
The battery is low and must be recharged. For this reason, the battery
should be charged for at least 40 hours.
E R R O R
Hex Code 05
P a r a m e t e r s L o s t
The contents of one or more parameters have been altered without new
data input by the user.
⇒
The contents of all parameters must be checked.
Note: This error can be cleared automatically by exiting Parameter
Mode.
E R R O R
Hex Code 06
P r o g r a m L o s t
The contents of one or more program sets have been altered without new
data input by the user.
⇒
The contents of all program sets used must be checked.
Note: This error appears only once, since a new checksum is
calculated each time an error is cleared.
E R R O R
Hex Code 07
contact the Indramat Service Department
D i v i s i o n b y Z e r o
The error is an internal software fault in the CLM. If this error occurs, all
parameters must be checked for validity.
E R R O R
Hex Code 08
I n v a l i d M o d e !
System inputs #1 and #2, Parameter and Automatic Mode, are on
simultaneously. Check CLM display screen for status of system inputs.