Omron CS1W-213 - REV 02-2008, Operation Manual

Page: 342 / 401

317
Error Code Lists Section 11-5
Common
parameters Operating data
area designation
error 0010 The operating data area designa-
tion (m) is incorrect.
• Area designation: Set to a set-
ting other than 00, 0D, or 0E.
• Bank designation: Set to a set-
ting not in the range 00 to 0C,
when 0E is set for the area des-
ignation.
In this condition, only the data save
operations can be performed. In this
case, the PCU's axis parameters and
data are all returned to their default
values if the unit version of the PCU is
earlier than version 2.3. If the unit ver-
sion of the PCU is version 2.3 or later,
only parameters and data for which an
error has been detected will be
returned to their default values.
After correcting the common parame-
ters (refer to
SECTION 4 ), reset the
power supply or restart the PCU.
Common
parameters Operating data
area address des-
ignation error 0011 The designation of the beginning
word of the operating data area’s
address (m+1) is outside the setta-
ble range. In this condition, only the data save
operations can be performed. In this
case, the PCU's axis parameters and
data are all returned to their default
values if the unit version of the PCU is
earlier than version 2.3. If the unit ver-
sion of the PCU is version 2.3 or later,
only parameters and data for which an
error has been detected will be
returned to their default values.
After correcting the common parame-
ters (refer to
SECTION 4 ), reset the
power supply or restart the PCU.
Parameter desig-
nation error 0013 The axis parameter designation
(m+2) is not set to 00 or 01.
Alternatively, the combination of
settings for the number of unused
axes is incorrect.
Axis designation
error 0014 The axis parameter designation
(m+2) is set to 01, and 1 is set for
an axis not controlled by the PCU.
Axis parameters Response timeout 0020 The axis parameters set in the
CPU Unit could not be read to the
PCU. Increase the cycle monitor time set
with CX-Programmer and either reset
the power supply or restart the PCU. If
this error occurs again, despite
increasing the cycle monitor time, it is
possible that there is a fault in the
PCU or somewhere in the PLC. Either
replace the whole PLC, or the PCU.
Group Name Code Cause Remedy