Omron CS1W-213 - REV 02-2008, Operation Manual

Page: 167 / 401

142
Transferring Data with CX-Position Section 5-7
Operating Memory Area
When the SAVE DATA Bit (word n+1, bit 14) is turned from OFF to ON, all
parameters and data are saved to flash memory.
5-6-3 Timing Chart for Saving Data
Data cannot be saved and transferred at the same time. Attempting to do so
will result in a multiple start error (error code 8000). It is also not possible to
save data while pulses are being output. The following diagram is a timing
chart for saving data.
When the data saving operation has been completed, the Data Transferring
Bit (word n+8, bit14) is turned from ON to OFF.
5-7 Transferring Data with CX-Position
It will be possible to use the CX-Position Support Software to read, write and
save data, and to monitor the operating status of the PCU.
Outline CX-Position is software that can be used for setting all kinds of data used by a
PCU as well as for monitoring the operating status of the PCU.
Creating and Transferring
Data Refer to the CX-Position Operation Manual (W433) for details on its operation.
While CX-Position is used to download data, or to save data to flash memory,
the Data Transferring Flag will be ON.
Note Do not carry out transfer operations from more than one CX-Position for the
same PCU at the same time. There is a probability of the data transfer not
being completed successfully, and of abnormal operation resulting.
Name Model Operating
memory area
Bit Contents
SAVE DATA NC4 @ 3
NC2 @ 3
NC1 @ 3
n+1
n+1
n+1 14 Starts saving
data at the ris-
ing edge.
Data Transfer-
ring Flag NC4 @ 3
NC2 @ 3
NC1 @ 3
n+8
n+4
n+2 14 1: Data is being
saved
0: Power up or
restart; saving
completed;
saving unsuc-
cessful
SAVE DATA
(n+1 , bit14)
Data Transferring Flag
(n+8, bit 14)
Normally 1 to 2 s
(30 s max.)
Downloading (or saving)
from CX-Position
Data Transferring Flag
(n+8, 14)
Downloading
Completion