Omron CS1W-213 - REV 02-2008, Operation Manual

Page: 132 / 401

107
Examples of Parameter Settings Section 4-8
Note Operation will be performed for PCUs with unit version 2.1 or earlier. The
emergency stop for the Y axis, however, requires wiring. Some parameter set-
tings will also vary.
Parameter Settings
• Set the default settings using the CX-Programmer.
• Make the following settings for the X axis.
• With the following settings, jog operation and direct operation can be per-
formed from the CPU Unit.
• When performing an origin search, make the settings and adjustments
according to each system.
m = 100 x unit number
= 100 x 0 = D20000
Default Settings and Set Values: Parameters for which individual bits have
specific applications are expressed in hexadecimal (e.g., 0000H).
Category Word Name Default setting Set value Remarks
Common
Parameters m Operating data area des-
ignation --- 0000H The operating data area
is allocated between to
m+60 and m+99.
m + 1 Beginning word of oper-
ating data area --- 0000H
m + 2 Axis parameter designa-
tion --- 1001H Only the X axis is used.
The operating data area
is allocated between
m+4 and m+59.
m + 3 Not used. --- 0000H