Omron CS1W-213 - REV 02-2008, Operation Manual

Page: 134 / 401

109
Examples of Parameter Settings Section 4-8
Note Operation will be performed for PCUs with version 2.1 or earlier. The emer-
gency stop for the Y axis, however, requires wiring. Some parameter settings
will also vary.
Parameter Settings
• Set the default settings using the CX-Programmer.
• Make the following settings for the X axis.
• With the following settings, jog operation and direct operation can be per-
formed from the CPU Unit.
• The present position is set to 0 every time the axis is started.
Take into consideration that the software limits will not operate and the
present position will be lost.
m = 100 x unit number
= 100 x 0 = D20000
Default Settings and Set Values: Parameters for which individual bits have
specific applications are expressed in hexadecimal (e.g., 0000H).
Category Word Name Default setting Set value Remarks
Common
Parameters m Operating data area des-
ignation --- 0000H The operating data area is
allocated between m+60
and m+99.
m + 1 Beginning word of oper-
ating data area --- 0000H
m + 2 Axis parameter designa-
tion --- 1001H Only the X axis is used.
Parameters m+4 to m+59
are used.
m + 3 Not used. --- 0000H