Omron CS1W-213 - REV 02-2008, Operation Manual

Page: 291 / 401

266
Memory Operation Section 10-2
Data Settings
Axis Parameters The values for D20004 onwards are transferred when the power is turned ON
(or at restart).
Positioning Sequences
Note Addresses other than the above should be set to their default settings (0).
Speed
Note Addresses other than the above should be set to their default settings (0).
Address Setting Contents of setting
1000 1011 Sequence #0 X axis designation
Output code: 0
Position designation: relative
Completion code: automatic
Dwell time #0
Acceleration time #0
Deceleration time #0
Initial speed #3
Target speed #1
1001 0000
1002 0301
1003 1012 Sequence #1 X axis designation
Output code: 0
Position designation: relative
Completion code: continuous
Dwell time #0
Acceleration time #0
Deceleration time #0
Initial speed #3
Target speed #1
1004 0000
1005 0301
1006 1012 Sequence #2 X axis designation
Output code: 0
Position designation: relative
Completion code: continuous
Dwell time #0
Acceleration time #0
Deceleration time #0
Initial speed #3
Target speed #2
1007 0000
1008 0302
1009 1013 Sequence #3 X axis designation
Output code: 0
Position designation: relative
Completion code: bank end
Dwell time #0
Acceleration time #0
Deceleration time #0
Initial speed #3
Target speed #0
100A 0000
100B 0300
Address Setting Contents of setting
112C 00C8 Speed #0 200 pps (C8 Hex)
112D 0000
112E 012C Speed #1 300 pps (12C Hex)
112F 0000
1130 01F4 Speed #2 500 pps (1F4 Hex)
1131 0000
1132 0000 Speed #3 0 pps (0 Hex)
1133 0000