Omron CS1W-213 - REV 02-2008, Operation Manual

Page: 323 / 401

298
Transferring and Saving Data Section 10-7
Data Memory Settings
READ DATA
NC213
The parameters for each axis are read from the flash memory of the PCU.
Transfer them in advance to the PCU and then save them.
WRITE DATA and SAVE DATA
NC113
Designation of the Operating Data Area
The operating data area is set during programming and therefore no setting is
necessary beforehand.
Data Settings
READ DATA
• Axis Parameters
• Positioning Sequences
• Speeds
• Positions
• Acceleration and Deceleration Times
• Dwell Times
• Zones
Transfer the data needed for the operation beforehand to the PCU for both the
X and Y axes, and save it in the flash memory.
WRITE DATA and SAVE
DATA The data in D03000 through D03799 is transferred to the PCU, so set all the
data such as the axis parameters, positioning sequences, speeds and so on,
in this DM Area.
Program
W030 and W031 are used as work words.
READ DATA
DM Setting Contents of setting
D20000 000D Sets the operating data area to D00500 onwards.
D20001 01F4
D20002 0000 Parameters read from PCU’s internal flash memory.
DM Setting Contents of setting
D20200 000D Set the operating data area to D00600 onwards.
D20201 0258
D20202 0000 Parameters read from PCU’s internal flash memory.