Omron CS1W-213 - REV 02-2008, Operation Manual

Page: 130 / 401

105
Examples of Parameter Settings Section 4-8
• The two axes are controlled.
• A Servo Drive is used for each axis.
• The pulse output method for the two axes is set to CW/CCW output (i.e.,
default setting).
• The two axes operate within the same operating range (1,000 to
1,000,000 pulses).
• The origin proximity signal and origin signal use N.O. contacts (i.e.,
default setting).
• The CW/CCW limit input signals uses N.C. contacts (i.e., default setting).
Parameter Settings
• Set the default settings using the CX-Programmer.
• Make the following settings for the X axis. Make the same settings for the
Y axis.
• With the following settings, jog operation and direct operation can be per-
formed from the CPU Unit.
• When performing an origin search, make the settings and adjustments
according to each system.
m = 100 x unit number
= 100 x 0 = D20000
Default Settings and Set Values: Parameters for which individual bits have
specific applications are expressed in hexadecimal (e.g., 0000H).
Category Word Name Default setting Set value Remarks
Common
Parameters m Operating data area des-
ignation --- 0000H The operating data area
is allocated between
m+60 and m+99.
m + 1 Beginning word of oper-
ating data area --- 0000H
m + 2 Axis parameter designa-
tion --- 0001H Parameters m m+4 to
m+59 are used.
m + 3 Not used. --- 0000H