Mitsubishi Electric Melservo-J3 Series MR-J3-B, Instruction Manual

Page: 627 / 802

16 - 72
16. INDEXER POSITIONING OPERATION
16.11 Parameters
CAUTION
Never adjust or change the parameter values extremely as it will make operation
instable.
If fixed values are written in the digits of a parameter, do not change these values.
Do not change parameters for manufacturer setting.
Do not set any values other than the described setting values to each parameter.
POINT
For any parameter whose symbol is preceded by *, set the parameter value
and switch power off once, then switch it on again to make that parameter
setting valid.
In this servo amplifier, the parameters are classified into the following groups on a function basis.
Parameter group Main description
Basic setting parameters
(No.PA
)
Make basic setting with these parameters. Generally, the operation is possible only with these
parameter settings.
Gain/filter parameters
(No.PB
)
Use these parameters when making gain adjustment manually.
Extension setting parameters
(No.PC
)
These parameters are inherent to the MR-J3- T servo amplifier.
I/O setting parameters
(No.PD
)
Use these parameters when changing the I/O devices of the servo amplifier.
Mainly setting the basic setting parameters (No.PA
) allows the setting of the basic parameters at the
time of introduction.