Hitachi Compute Blade 2000, User Manual

Page: 607 / 1927

556
6
Manag
eme
nt
Modul
e S
ett
in
gs
If you enter
S
in the switch module setting menu and press Enter , the current switch
module setting is displayed.
If you enter
W
in the switch module setting menu and press Enter , the switch module
setting held by the management module is displayed and you are asked to select a
switch module at the prompt.
Enter the slot number of the switch module, and a message to confirm the change is
displayed. At the prompt, enter
Y
and press Enter , and the switch module setting held
by the management module is applied to the network setting of the switch module. To
cancel the setting change, enter
N
and press
Enter
or just press
Enter
.
(A,N,S,W,[Q]) : S
-- Switch module current network setting --
SW IP address Subnetmask Default gateway
-- --------------- --------------- ---------------
0 192.168. 1.111 255.255.255. 0 192.168. 1.128
1 ------------- ------------- -------------
2 ------------- ------------- -------------
3 ------------- ------------- -------------
4 ------------- ------------- -------------
5 ------------- ------------- -------------
Hit enter key.
(A,N,S,W,[Q]) : W
-- Switch module network setting --
SW Ext IP address Subnetmask Default gateway Ext port Synchronize
-- ---- ---------------- --------------- --------------- -------- -----------
0 Ext 192.168. 1.111 255.255.255. 0 192.168. 1.128 MGMT-0 Yes
1 Int -------------- ------------- ------------- ------ ---------
2 Int -------------- ------------- ------------- ------ ---------
3 Int -------------- ------------- ------------- ------ ---------
4 Int -------------- ------------- ------------- ------ ---------
5 Int -------------- ------------- ------------- ------ ---------
Select switch module (0-5,A=All,[Q=Quit]) : 0
Confirm? (Y,[N]) : Y
- <Switch module0> Writing setting was completed.
Hit enter key.