Hitachi Compute Blade 2000, User Manual

Page: 314 / 1927

263
5
Server B
lad
e S
etup
Display item Display/content Setting/display value **
at system startup
M Reconstruction Rate
*3
Priority of capacity expansion 0 to 100 / [30]
N Spinup Delay *3 Timing for hard disk motors to start
at system startup
0 to xxx / [6]
O NCQ *4 Setting the NCQ command [Enabled] / Disabled
*1 This can be changed only when no disk arrays have been set at all.
*2 Do not use
Set Factory Defaults . This setting must be changed to the recommended values.
*3 Change the value to the recommanded value.
*4 Always use the
Default setting.

Place the mouse cursor on a setting item and left-
click the mouse to change the setting values. Or,
left-click the mouse to move the cursor and enter
a value from the keyboard. Click Submit after the
setting.

Values of Spin Drive Count and Spin Delay are
fixed, which will not take effect even though you
have changed the values.