Hitachi Compute Blade 2000, User Manual

Page: 313 / 1927

262
5
Server B
lad
e S
etup
Display item Display/content Setting/display value **
P Spin Down Delay
Time *4
Setting the saving mode to a hard
disk
0 to 1440 / [30]
*1 This can be changed only when no disk arrays have been set at all.
*2 Do not use
Set Factory Defaults . This setting must be changed to the recommended values.
*3 Change the value to the recommanded value.
*4 Always use the
Default setting.
Firmware version; 2.120.233-1474 or later
Display item Display/content Setting/display value **
A Battery Backup Battery backup unit mount status. None
B Coercion Mode *1 Setting the capacity control for the
physical hard disk used for disk
array building
[None (using the entire capacity)] /
128MB-way (using a capacity as a
multiple of 128MB) / 1GB-way
(using a capacity as a multiple of
1GB)
C Set Factory Defaults
*2
Returning all the settings to their
Defaults values
－
D S.M.A.R.T Polling *4 Setting the interval of S.M.A.R.T.
reporting
0 to 65535 / 300 / [600]
E Cluster Mode *3 Setting the cluster mode [Disabled (invalid)] / Enabled (valid)
F Alarm Control Sounding the buzzer on the
controller in the event of a fault at a
connected device
[Disabled (not sounding)] / Enabled
(sounding) / Silence (stop sounding
temporarily)
G Rebuild Rate *3 Priority of rebuilding 0 to 100 / [30]
H Patrol Read Rate *3 Priority of patrol reading 0 to 100 / [30]
I BGI Rate *3 Priority of background initializing 0 to 100 / [30]
J Cache Flush Interval
*3
Flush timing for write-cache data 1 to 255 / [4]
K CC Rate *3 Priority of consistency inspection 0 to 100 / [30]
L Spinup Drive Count *4 Number of hard disk motors to start 0 to 8 / [1]