Hitachi Compute Blade 2000, User Manual

Page: 1589 / 1927

1538
1
3
S
yst
em
O
p
er
at
ion and Man
agem
ent
 If using Basic mode, make sure that the active partition can boot from the
SAN.
 If using LP mode, make sure that the LPAR configured in LPAR manager
on the active partition can boot from the SAN. (LP mode is supported by
BSM Plus.)
After completing these checks, use the BSM Plus or HCSM to set up the N+M
cold standby configuration.
(6) N+M switching test run
Before starting operation, conduct an N+M switching test run to confirm that
switching is performed successfully by one of the following:
 Performing a manual failover from the BSM Plus
 Operating the test N+M cold standby using HCSM
 Issuing a switching test alert using the BSM Command or HCSM Command
For details about the N+M cold standby configuration and
N+M switching procedure, see your BSM Plus or HCSM
documentation.
NOTICE
When a switching alert is issued by the BSM command execution, the active
partition is forcibly powered off.