Omron F250-UME, Руководство пользователя программного обеспечения

Страница: 857 / 999

6-2-(7)
Normal Serial Interface Section 6-2
The Communications (Serial) window will be displayed.
5. Set each parameter to the desired setting.
6. Select End.
The displayed settings will be registered and the System settings menu
(from step 3) will be displayed.
The following table shows the possible communications settings. The as-
terisk (*) indicates the default setting
.
Note a) RS-232C standards are not defined for speeds over 20 kbps. De-
pending on the cable length, communications may be unreliable
at speeds of 38,400 bps and higher when RS-232C is selected.
If there are problems with communications, reduce the baud rate
to 19,200 bps.
b) XMODEM (-1K) is not supported.
CHECK
Make the following settings when saving or loading with commands such
as SCNLOAD and SCNSAVE.
SeeAlso
Refer to
1RUPDO&RPPXQLFDWLRQVRQSDJH
for details on setting the
flow control.
Communications (Serial)
Interface
Baud rate
Data length
Parity bits
Stop bits
Mode
Protocol
End
RS-232C
38400bps
8bit
None
1bit
Normal
XMODEM
:
:
:
:
:
:
:
Item Possible settings
Interface RS-232C* or RS-422
Baud rate
(See note a.) 2,400, 4,800, 9,600, 19,200, 38,400*, 57,600,
115,200 (bps) Set the same
settings that
are set in the
personal com-
puter.
Data length 7 or 8* (bits)
Parity bits None*, Odd, or Even
Stop bits 1* or 2 (bits)
Mode Select Normal.
Transfer protocol
(See note b.) XMODEM*, ZMODEM Set the same
settings that
are set in the
personal com-
puter.
Item Possible settings
Data length 8 bits
Parity bits None
Stop bits 1 bit
Flow control None