2-16-(17)
EC Positioning
Section 2-16
4.
Only one angle (
q
) will be output as the measurement results for the lines
that are found. Select which position
q
will be obtained.
Midline of Corner*
The asterisk (*) indicates the default setting.
Side 1 and Side 2
With the target color between the two sides, the side in the clockwise di-
rection is side 1 and the side in the counterclockwise direction is side 2.
CHECK
If both specifying angle and specifying length are set to OFF and there are
multiple lines displayed on the screen, the cross point of the longest line and
the line that crosses it will be found.
1.
Display the figure selections using the same procedure as outlined in steps
1 to 3 for Circle.
SeeAlso
Refer to page 2-16-(25).
2.
Select Cross point.
The settings selections will be displayed.
Obtained midline
between two sides.
Side 2
Side 1
New registration(Region0)
Circle
Cross point
Box
Multi-points
Measurement conditions
Line conditions
Search region
Reference registration
Clear
Содержание F250-UME
