Description
Error/Warning Message
Error/Warning
ID
Refer to the error message text.
The shelf identifier for a subtended shelf cannot be
provisioned through CTC. It must be changed using
the LCD.
EID-6140
Refer to the error message text.
The DHCP server could not be changed.
EID-6143
If the port is not pre-provisioned with
the type of media that is going to be
inserted, you cannot access any of the
existing values for the port.
The port provisioning cannot be changed when the port
media is Undefined.
EID-6144
Refer to the warning message text.
OSPF on LAN should only be enabled when the LAN
routers run OSPF. Otherwise, the node will not be
reachable from outside its subnet. RIP implementation
only advertise routes in one direction to connected
routers. It does not learn or distribute routes advertised
by other routers. Also note that enabling OSPF on the
LAN will temporarily cause the current list of static
routes to stop being advertised to remote nodes and
only be used locally.
WID-6145
Refer to the warning message text.
Deleting the protection group while in a switched state
might cause a loss of traffic. It is recommended that
you verify switch states before proceeding.
WID-6146
Refer to the error message text.
The LAPD MTU size must be greater than or equal to
the {0} LSP buffer size {1}. Alternatively, you can
decrease the {0} LSP buffer size to {2}.
EID-6149
Enter a value that is within the range.
The value is out of range.
EID-6150
Refer to the error message text.
The minimum span loss must be less than the maximum
span loss.
EID-6151
Enter the NTP/SNTP server name. To
leave this field empty, uncheck the
Use NTP/SNTP Server" and proceed.
The "Use NTP/SNTP Server" field is checked. Enter
the NTP/SNTP server IP address or server name.
EID-6152
Refer to the error message text.
The maximum frame size is invalid.
EID-6153
Refer to the error message text.
To combine unidirectional two-port provisioning and
autonegotiation on the same port, autonegotiation must
be set first.
EID-6154
Refer to the error message text.
Transponder mode cannot be provisioned with circuits
on the card.
EID-6155
The transponder is not configured
properly.
The transponder configuration is invalid.
EID-6156
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
541
Error Messages
Error Messages Reference
