Description
Error/Warning Message
Error/Warning
ID
The frame size must be in the specified
range. This can increment by the
specified value.
The maximum frame size must be between {0} and {1}
and may be increased in increments of {2}.
EID-3381
The number of credits must be
between the specified values.
The number of credits must be between {0} and {1}.
EID-3382
The GFP buffers must be in the
specified range. This can increment
by the specified value.
The GFP buffers available must be between {0} and
{1} and may be increased in increments of {2}.
EID-3383
Refer to the warning message text.
You are about to force the use of Secure Mode for this
chassis. You will not be able to undo this operation. Is
it OK to continue?
WID-3384
Refer to the error message text.
{0}. Delete the circuits and try again.
EID-3385
The specified transponder mode
cannot be provisioned.
The transponder mode could not be provisioned: {0}
EID-3386
All the card ports should be changed
to out-of-service before changing the
parameters.
You must change port(s) {0} to an out-of-service state
before changing card parameters. Click Reset to revert
the changes.
EID-3387
Refer to the error message text.
The card mode cannot be changed because the card has
circuits.
EID-3388
Refer to the error message text.
An error occurred while changing the card mode.
EID-3389
Refer to the error message text.
The port is in use.
EID-3390
You cannot change the port rate of a
card that has been deleted.
The port rate cannot be changed because the port has
been deleted.
EID-3391
Refer to the warning message text.
The timing reference(s) could not be assigned because
with external timing, only a single protected, or two
unprotected timing references per BITS Out can be
selected. Please use the "Reset" button and verify the
settings.
WID-3392
Refer to the warning message text.
The timing reference(s) could not be assigned because
with line or mixed timing, only a single unprotected
timing reference per BITS Out can be selected. Please
use the "Reset" button and verify the settings.
WID-3393
Refer to the error message text.
An error occurred while refreshing the power
monitoring values.
EID-3394
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
516
Error Messages
Error Messages Reference
