Description
Error/Warning Message
Error/Warning
ID
Refer to the warning message text.
The port state cannot be indirectly transitioned because
the port aggregates OCHCC circuits: if the port state
needs to be changed, edit it directly through port
provisioning.
WID-5051
You may have selected the incorrect
switch.
The operation is not valid for the connection type.
EID-5052
Refer to the error message text.
The operation cannot be performed because the
connection is under test access.
EID-5053
Refer to the error message text.
The TL1 tunnel could not be opened. {0}
EID-5054
Refer to the error message text.
Some patchcords were not deleted. Patchcords cannot
be deleted if they are incomplete or support any circuits,
or if the nodes supporting them are not connected.
EID-5055
Remove the circuits provisioned over
the provisionable patchcord before
trying to delete it.
This PPC cannot be deleted because one or more
circuits are provisioned over it.
EID-5056
Refer to the error message text.
The addition of the last node has not yet finished. Please
wait before trying to add a new node.
EID-5057
Refer to the error message text.
An OCHNC upgrade is applicable only to bidirectional
circuits.
EID-5058
CTC encountered a complete failure
while upgrading optical channel
network connection.
The OCHNC upgrade failed. One or more
communication failures occurred during the operation.
EID-5059
CTC encountered a partial failure
while upgrading an optical channel
network connection.
The OCHNC upgrade partially failed. One or more
communication failures occurred during the operation.
Create the OCHCC manually.
EID-5060
Refer to the error message text.
The overhead circuit source and destination must reside
on the same shelf.
EID-5061
A four-fiber BLSR needs four cards.
A four-fiber {0} cannot be created using three cards.
EID-5062
Refer to the warning message text.
The profile "{0}" includes a change to the OPEN-SLOT
alarm severity. This change is disallowed for the ONS
15600. "{1}" will continue to use the OPEN-SLOT
severity of MN that is included in the default
configuration. Other changes from the "{2}" profile
were successfully applied to {3}".
WID-5063
This indicates the status of path
protection switching.
{0}
{1}
EID-5064
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
524
Error Messages
Error Messages Reference
