Description
Error/Warning Message
Error/Warning
ID
Refer to the error message text.
WDMANS parameter cannot be removed.
This may be in use by the system.
EID-4036
Refer to the error message text.
This operation is not supported on the protect entity of
a protection group.
EID-4037
Refer to the error message text.
The bandwidth for the configuration modes is allocated
once the payload for the PPMs are provisioned.
In case of MXP_MR mode the bandwidth is allocated
only after a circuit is created.
EID-4051
Refer to the error message text.
ODU Utilization is not supported for this mode.
Bandwidth utilization is not valid for Operating mode
provisioned on the PPM.
EID-4052
Refer to the error message text.
A valid route cannot be found for the tunnel change
request.
EID-5000
Refer to the error message text.
The tunnel could not be changed.
EID-5001
Refer to the error message text.
The tunnel could not be restored and must be recreated
manually.
EID-5002
Refer to the error message text.
The circuit roll failed. {0}
EID-5003
There is already one 4F BLSR
provisioned on the set of nodes
involved in the ring. The maximum
number of 4F BLSR rings has been
reached for that node.
There is already one four-fiber {0} provisioned on the
set of nodes involved in {1}. The maximum number of
four-fiber {0} rings has been reached for that node.
EID-5004
Refer to the warning message text.
A non-zero hold-off time can violate switching time
standards, and should only be used for a circuit with
multiple path selectors.
WID-5005
You should use different secondary
end point only for DRI or open-ended
path protected circuits.
Warning: A different secondary {0} node should only
be used for DRI or open-ended path protected circuits.
WID-5006
Refer to the warning message text.
If you change the scope of this view, the contents of
this profile editor will be lost.
WID-5007
Refer to the warning message text.
Please ensure that all the protection groups are in proper
states after the cancellation.
WID-5008
No VT capable STSs are available at
the node.
The circuit {0} is not upgradable. No {1} capable {2}s
are available at the node {3}.
WID-5009
Refer to the error message text.
The domain name already exists.
EID-5010
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
520
Error Messages
Error Messages Reference
