2.
In the TL1 command line, enter a command using the following syntax:
DETAILED STEPS
Step 1
Open a TL1 command line (click
Tools > Open TL1 Connection
).
Step 2
In the TL1 command line, enter a command using the following syntax:
SET-TH-OCH:[<TID>]:<AID>:<CTAG>::<MONTYPE>,<THLEV>,[<LOCN>],,[<TMPER>];
where:
• Access Identifier (AID) identifies the NE to which the command pertains. All the OCH, STS, VT1, facility, and
DS1 AIDs are supported.
• The parameter MONTYPE is the monitored type.
• The parameter THLEV is optional and indicates a threshold count value (the number of errors that must be exceeded
before the threshold is crossed).
• The parameter LOCN specifies the location associated with the particular command.
• The parameter TMPER is optional and is an accumulation time period for performance counters, with possible values
of 1-DAY, 1-HR, 1-MIN, 15-MIN, and RAW-DATA.
For a more information about this command and a list of TL1 commands, refer to the
Cisco ONS SONET
TL1 Command Guide
and
Cisco ONS SDH TL1 Command Guide
.
Note
Provision Optical TCA Thresholds
Complete the following procedure to provision TCA thresholds in CTC.
SUMMARY STEPS
1.
In card view, click the
Provisioning > Optics Thresholds
tabs.
2.
In the Types area, click
TCA.
3.
In the Intervals area, click
15 Min
.
4.
In the Laser Bias High (%) field, enter the threshold value, for example, 81.0 percent.
DETAILED STEPS
Step 1
In card view, click the
Provisioning > Optics Thresholds
tabs.
Step 2
In the Types area, click
TCA.
Step 3
In the Intervals area, click
15 Min
.
Step 4
In the Laser Bias High (%) field, enter the threshold value, for example, 81.0 percent.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
31
General Troubleshooting
Provision Optical TCA Thresholds
