Description
Error/Warning Message
Error/Warning
ID
You cannot flush the cache in the
Tunnel identifier Address Resolution
Protocol (TARP) state.
The TARP data cache cannot be flushed.
EID-6071
You cannot add the specified cache
entry.
The TARP data cache entry cannot be added: {0}
EID-6072
Refer to the warning message text.
A TARP request has been initiated. Try refreshing the
TARP data cache later.
WID-6073
Refer to the error message text.
End system mode only supports one subnet.
EID-6074
CTC is removing the MAT entry.
An error occurred while trying to remove a MAT entry.
The entry does not exist.
EID-6075
CTC cannot add the specified
adjacency entry for reasons unknown.
An error occurred while trying to {0} a TARP manual
adjacency entry: {1}
EID-6076
The area address should not be more
than 13 characters.
The area address must be between 1 and 13 bytes long,
inclusive.
EID-6077
The specified Tunnel Identifier does
not exist.
A TDC entry with this TID {0} does not exist in the
table.
EID-6078
You must enable TARP to remove the
TDC entry.
A TDC entry with this TID {0} could not be removed.
Please verify that TARP is enabled.
EID-6079
Refer to the warning message text.
Router {0} does not have an area address in common
with Router 1. Switching from IS L1/L2 to IS L1 in
this case will partition your network.
WID-6080
CTC does not allow more than 10
RADIUS servers.
The limit of 10 RADIUS server entries has been
reached.
EID-6081
The Shared Secrets field should not
be empty.
{0} cannot be empty.
EID-6082
Refer to the error message text.
The entry you selected for editing has been altered by
another user. The changes cannot be committed.
EID-6083
Specify another RADIUS server entry.
The RADIUS server entry already exists.
EID-6084
Refer to the warning message text.
Disabling shell access will prevent Cisco TAC from
connecting to the vxWorks shell to assist users.
WID-6085
The card you are trying to remove is
being used. Cannot change the card.
The card cannot be changed because card resources are
in use.
EID-6086
Refer to the error message text.
The card cannot be changed because the card type is
invalid or incompatible.
EID-6087
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
537
Error Messages
Error Messages Reference
