Lucent Technologies WaveStar OLS 40G, Руководство по установке

Страница: 482 / 578

11-10
Issue 1.0 March 2001
365-575-389
Installation Manual
Connecting SONET/SDH Systems to WaveStar OLS
40G
Connect SONET/SDH to Optical Line
System (OLS) (Continued)
Connect
Compatible
SONET/SDH
Transmitter to OLS
(continued) Table 11-2. OLS-Compatible Low-Speed Transmitter Output Levels
(continued)
Tx Channel
Output Connector Power Levels
42-Type OTU 43-Type OTU 44-Type OTU
Wavelength 12 -10.8 to -8.8 dBm -13.8 to -11.8 dBm -10.8 to -8.8 dBm
Wavelength 13 -11.4 to -9.4 dBm -14.4 to -12.4 dBm -11.4 to -9.4 dBm
Wavelength 14 -11.9 to -9.9 dBm -14.9 to -12.9 dBm -11.9 to -9.9 dBm
Wavelength 15 -12.1 to -10.1 dBm -15.1 to -13.1 dBm -12.1 to -10.1 dBm
Wavelength 16 -11.2 to -9.2 dBm -14.2 to -12.2 dBm -11.2 to -9.2 dBm
Step Action
4 Momentarily remove then reconnect the fiber on the transmitter or OTU/
OTPM OUT jack.
Requirement: The optical power meter shows a momentary loss of
optical power. (Power drops at least 25 dB on the meter.)
5 At the WaveStar OLS 40G, connect the measured jumper to the
corresponding OMU Port, i.e., the fiber from a wavelength-1 transmitter
goes to OMU OCHAN1 IN, the fiber from a wavelength-2 transmitter goes
to OMU OCHAN2 IN, etc.
Requirement: The FAULT LED shall extinguish on the transmitting OA
when the first channel is added.
6 Proceed to Connect Optical Line System to SONET/SDH/1-Gb Ethernet:
page 11-11, to confirm the new wavelength end-to-end.