Lucent Technologies WaveStar OLS 40G, Руководство по установке

Страница: 218 / 578

5-62
Issue 1.0 March 2001
365-575-389
Installation Manual
Wired Cable Installation
OLS/OT Integration Cables
Installation (Continued)
Rack and Stack
Configurations
(continued) Table 5-37. Additional Cables Required for Five-Bay Rack and Stack
Follow the steps below to install the inter shelf cables for Bays 1-3.
(Continued on next page)
ED Cable Group Connectors
7G028-22 803 J15 BUS IN J5 IAO LAN
7G028-22 806 J7 CTL OUT J6 CTL IN
7G028-22 812 J27 CTL OUT J16-1
J8-1
J16-2
J8-2 RESET IN
EQPG OUT
RESET IN
EQPG OUT
Step Action
1 Remove the ED7G028-20 Group 29 cable from the Bay 1 OLS shelf J27
and OT System Controller shelf J8 and J16 connectors.
2 Route the P27 end of the E-D7G028-22 Group 812 cable through the
right side of the OLS shelf of Bay 1 and attach to the J27 CTL OUT (B)
connector on the OLS interconnection panel from which the G29 cable
was removed in Step 1.
3 Route the P8-1/P16-1 ends of the same cable through the right side of
the OT System Controller Shelf (middle shelf of Bay 1) to the
interconnection panel.
4 Attach P8-1 to the J8 EQPG OUT connector on the OT System Controller
Shelf in Bay 1 (middle shelf).
5 Attach P16-1 to the J16 RESET IN connector on the OT System
Controller Shelf in Bay 1.
6 Route the P8-2 and P16-2 ends of the same cable through the left side of
the second OT System Controller shelf in Bay 2, to the interconnection
panel.
7 Attach P8-2 to the J8 EQPG OUT connector on the OT System Controller
Shelf in Bay 2.
8 Attach P16-2 to the J16 RESET IN connector on the OT System
Controller Shelf in Bay 2.