Lucent Technologies WaveStar OLS 40G, Руководство по установке

Страница: 134 / 578

4-8
Issue 1.0 March 2001
365-575-389
Installation Manual
Power Cable Installation
Multiple OT Shelf Configurations
Introduction This section describes the power cable selection and installation for systems with
multiple OT shelves in the same cabinet or equipment bay frame.
For power cable installation information of OLS shelves, OLS shelf with OT
shelves in the same bay, or single OLS shelves, refer to the appropriate section of
this chapter.
OT Power Cable
Connection Table 4-2. Available Power Cables for Multiple OT Shelf Configurations
Install as follows:
(Continued on next page)
ED-9C103-22
Cable Group
Cable Length
(ft.)
Use With
Power Bus Color
5 or 31 15 A Red
6 or 24 15 B Blue
15 or 32 As Required A Red
16 or 26 As Required B Blue
Step Action
1 Turn the power breakers off, or do not install fuses, at the BDFB.
2 Verify the circuit packs are not installed in the shelves.
Leave the BDFB fuses out or breakers off until performing the steps in
Chapter 8, “Powering” of this manual.
3 If power is being fed by an overhead cable rack, route power cable out
through the top of the bay/cabinet as shown in Figure 4-3 on page 4-10. If
power is being fed from a raised floor storage tray, route power cables as
shown in Figure 4-4 on page 4-11.