Lucent Technologies WaveStar OLS 40G, Руководство по установке

Страница: 211 / 578

Issue 1.0 March 2001
5-55
365-575-389
Installation Manual Wired Cable Installation
OLS/OT Integration Cables
Installation (Continued)
Rack and Stack
Configurations
(continued)
(Continued on next page)
Step Action
9 Remove the ED-7G045-20 G2 Termination from J7 on the
interconnection panel of the top shelf, OT Complimentary 1 Shelf in Bay
1.
10 Remove the ED-7G045-20 G6 termination from the J15 connector on the
OLS shelf in Bay 1 and discard.
11 Route the P15 end of the ED-7G028-22 G803 cable through the right
side of the OLS shelf in Bay 1 and attach to the J15 BUS IN connector.
12 Route the P5 end of the same ED-7G028-22 G803 cable through the left
side of the OT System Controller Shelf of Bay 2 and connect to the J5
IAOLAN connector.
13 Remove the ED-7G045-20 G2 termination from J7 of the OT System
Controller Shelf of Bay 2.
14 Route the P7 end of the ED-7G045-20 G6 cable through the left side of
the OT System Controller Shelf of Bay 2 and attach P7 to the J7 CTL
OUT connector.
15 Route the P6 end of the same cable through the left side of the OT
Complimentary 1 shelf in Bay 2 and attach P6 to the J6 CTL IN
connector.
16 Route the P9 end of the ED-7G045-20 G7 cable through the left side of
the OT System Controller Shelf of Bay 2 and attach P9 to the J9 EQPG
IN 1 connector.
17 Route the P8 end of the same cable through the left side of the OT
Complimentary 1 shelf in Bay 2 and attach P8 to the J8 EQPG OUT
connector
18 Route the P13 end of ED7G045-20 G9 cable through the left side of the
OT System Controller Shelf of Bay 2 and attach P13 to J13 RESET OUT
1 connector.
19 Route the P16 end of the same cable through the left side of the OT
Complimentary 1 shelf in Bay 2 and attach P16 to the J16 RESET IN
connector.