Lucent Technologies WaveStar OLS 40G, Руководство по установке

Страница: 200 / 578

5-44
Issue 1.0 March 2001
365-575-389
Installation Manual
Wired Cable Installation
OLS/OT Integration Cables
Installation (Continued)
One OLS Shelf/
Two OT System
(continued)
(Continued on next page)
Step Action
2 Route the J14 end of the ED-7G028-22 G801, 851, or 853 cable through
the left side of the OLS shelf and attach to the P14 BUS OUT connector.
Refer to Figure 5-1to locate the connector.
3 Route the P5/P6 ends of the same cable through the left side of the OT
System Controller #1 shelf to the interconnection panel.
4 Remove the ED-7G045-20 G2 termination from the J6 CTRL IN
connector of OT System Controller #1 shelf and attach P6.
5 Attach P5 to the J5 IAO LAN connector of OT System Controller #1 shelf.
Refer to Figure 5-3 to locate the connectors.
6 Route the P27 end of the ED-7G028-22 G812, 813, or 814 cable through
the right side of the OLS shelf and attach to the J27 CTL OUT (B)
connector on the OLS interconnection panel. Refer to Figure 5-1 to locate
the connector.
7 Route the P8-1/P16-1 ends of the same cable through the left side of the
first OT System Controller #1 shelf to the interconnection panel.
8 Attach P8-1 to the J8 EQPG OUT connector on OT System Controller #1
shelf.
9 Attach P16-1 to the J16 RESET IN connector of OT System Controller #1
shelf. Refer to Figure 5-3 to locate the connectors.
10 Route the P8-2/P16-2 ends of the same cable through the left side of the
second OT System Controller #2 shelf to the interconnection panel.
11 Attach P8-2 to the J8 EQPG OUT connector of OT System Controller #2
shelf.
12 Attach P16-2 to the J16 RESET IN connector of OT System Controller #2
shelf. Refer to Figure 5-3 to locate the connectors.