Lucent Technologies WaveStar OLS 40G, Руководство по установке

Страница: 403 / 578

Issue 1.0 March 2001
9-13
365-575-389
Installation Manual Local Installation Testing
Auto Turnup Local Test
Auto Turnup Local
Test Description This test verifies the customer maintenance signal (CMS) connections on the TLM
packs and verifies the supervisory (SUPR) signal path through the TLM and OA
units and the intrashelf jumpers. The test may take up to 5 minutes to complete. A
more detailed description of the test is given in Chapter 11.
If failed slots are indicated, replace the circuit pack. Repeat the test until all lines
pass the test. If the line is not fully equipped, move circuit packs into unequipped
lines and repeat the test. If many different circuit packs fail in the same slot, there
may be a wiring problem on the shelf. If so, contact your next level of support.
Also, since an optical loopback is required, this test verifies proper operation of the
jumpers to the LGX.
Auto Turnup Local
CMS Test
Procedures Perform the following steps for the Auto Turnup Local CMS test:
(Continued on next page)
Step Action Reference
1 Verify there are no fiber connections to the OA input and
output connectors at the LGX panel.
2 Loop the customer maintenance signal connectors (CM
IN to CM OUT) using multimode fiber jumpers. (These
are usually colored grey or orange.) See
Figure 9-5,
Figure 9-6,
and
Figure 9-7.
3 Execute CONFIGURATION.Update.System.
4 Select the command Fault.Test.Auto.Local and Press
Enter.
NOTE:
Login in expert mode if the command is not found.