Lucent Technologies WaveStar OLS 40G, Руководство по установке

Страница: 411 / 578

Issue 1.0 March 2001
9-21
365-575-389
Installation Manual Local Installation Testing
Auto Turnup Local Tests (Continued)
Auto Turnup Local
SUPR Procedures
for Repeaters Use the following procedures to perform the Auto Turnup Local SUPR Test for
Repeaters:
(Continued on next page)
Step Action Reference
1 Disable APSD. See Danger
on previous
page3.
2 Loop back the line 1 high speed signals by connecting
the OA 1A output to the OA 1B input through 33 dB of
attenuation and the OA 1B output to the OA 1A input
through 33 dB of attenuation. Figure 9-11
3 If Line 2 is populated, loop back the line 2 high-speed
signals by connecting the OA 1A output to the OA 1B
input through 33 dB of attenuation and the OA 1B output
to the OA 1A input through 33 dB of attenuation. Figure 9-11
4 Verify the customer maintenance signal connectors are
not looped.
5 Execute CONFIGURATION.Update.System.
Requirement: The command clears loss of signal
alarms. FAULT LEDs on both OAs are off and are not
flashing.
6 Execute FAULT.Test.Auto.Local. Enter SUPR-ALL in
the provided box and click on enter. This test will take up
to 5 minutes, depending on how many lines are
equipped.
Requirement: Results will be displayed on the CMC
screen. A GOOD represents a good slot. A FAIL
represents a failed slot. A “-” represents an untested slot
(no circuit pack equipped). If any slot fails, move its
circuit pack to a good slot and verify the test again.
Replace the circuit pack in the failed slot if indicated that
the failure moves with the pack.