Lucent Technologies WaveStar OLS 40G, Руководство по установке

Страница: 144 / 578

4-18
Issue 1.0 March 2001
365-575-389
Installation Manual
Power Cable Installation
Miscellaneously Mounted OT Shelves
(Continued)
List 10 OT Cable
Installation
(continued)
To install the intershelf power cable for the B supply perform the following:
(Continued on next page)
Step Action
1 Locate B supply power cable ED-9C103-22 GR6/24 or GR16/26. The
supply end of the cable will have a BLUE jacket.
2 Take the connector farthest from the supply end and put it through the
right access hole of the System Shelf (lowest shelf). Align plug with PWR
B connector checking that the locking clip is on the left side and the BLUE
(–48 V) is at the lower end of the connector. Push connector in until
locking tab snaps in place.
3 Select the connector of the remaining two that is farthest from the supply
end and put it through the right access hole of the Complementary Shelf
1 (middle shelf). Align plug with PWR B connector checking that the
locking clip is on the left side and the BLUE (–48 V) is at the lower end of
the connector. Push connector in until locking tab snaps in place.
4 Take the remaining connector and put it through the right access hole of
the Complementary Shelf 2 (top shelf). Align plug with PWR B connector
checking that the locking clip is on the left side and the BLUE (–48 V) is at
the lower end of the connector. Push connector in until locking tab snaps
in place.
5 Route excess cable into bay frame channel on right side and tie to frame.
6 Secure cable at entrance to top of frame.