Lucent Technologies WaveStar OLS 40G, Руководство по установке

Страница: 186 / 578

5-30
Issue 1.0 March 2001
365-575-389
Installation Manual
Wired Cable Installation
Line Orderwire, Section Orderwire,
and Section User Channel Cables
Installation (Continued)
Section User
Channel Cable
Connection
(continued) Section User Channel Cable Installation Procedure
Perform the following steps to install the Section User Channel cable:
Section Orderwire
Cable Connection Table 5-19 lists Section Orderwire cable connections and designations:
Table 5-19. Section Orderwire Cable Connection
(Continued on next page)
Step Action
1 Route the cable through the left side of the OLS shelf to the user channel
equipment. Refer to Figure 5-1 on page 5-4, OLS Interconnection Panel,
to locate the corresponding jacks/plugs.
2 Connect the section user channel cable to J2, J5, J8, and J11 on the
interconnection panel.
3 Connect the section user channel cable to the section user channel
equipment by cutting the cable to length and wire-wrapping the loose
ends onto the user channel unit.
4 Label the connections that are wire-wrapped.
5 Dress and tie the cable
Name Designation Pin Wire Color
Overhead E1 Clock Input N OE1CIN 1 BL-W
Overhead E1 Sync Input N OE1SIN 2 O-W
Overhead E1 Data Input N OE1DIN 3 G-W
Overhead E1 Data Output N OE1DON 4 BR-W
Overhead E1 Sync Output N OE1SON 5 S-W
Overhead E1 Clock Output N OE1CON 6 BL-R
No Connection None 7 None
No Connection None 8 None