Mitsubishi Melsec-Q QD75D1, User Manual

Page: 152 / 858

5 - 48
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Pr.47 Creep speed
Set the creep speed after near-point dog ON (the low speed just before stopping
after decelerating from the OPR speed).
The creep speed is set within the following range.
( Pr.46 OPR speed ) ( Pr.47 Creep speed) ( Pr.7 Bias speed at start)
Note) The creep speed is related to the detection error when using the OPR
method with zero signal, and the size of the collision if a collision occurs
during OPR method using the stopper method.
ON
V
Machine
OPR start
Near-point
dog signal OFF
Zero signal
OPR speed
Pr.46
Creep speed
Pr.47
[Table 1]
Pr.1 setting value
Value set with peripheral device
(unit)
Value set with sequence program
(unit)
0 : mm 0.01 to 20000000.00 (mm/min) 1 to 2000000000 (
×
10
-2
mm/min)
1 : inch 0.001 to 2000000.000 (inch/min)
1 to 2000000000 (
×
10
-3
inch/min)
2 : degree 0.001 to 2000000.000 (degree/min) 1 to 2000000000 (
×
10
-3
degree/min)
3 : pulse 1 to 1000000 (pulse/s) 1
[QD75P N/QD75D N]
1 to 4000000 (pulse/s)
[QD75P /QD75D ]
1 to 1000000 (pulse/s)
1: In GX Configurator-QP, the QD75P N/QD75D N are recognized as the QD75P /QD75D .
Therefore, the setting ranges are the same as those of the QD75P /QD75D . To set a value
outside a setting range in GX Configurator-QP, set it through a sequence program or GX Works2.
The setting ranges in GX Works2 are the same as those in sequence programs. (Refer to
Appendix 1.2)