Mitsubishi Melsec-Q QD75D1, User Manual

Page: 665 / 858

15 - 27
MELSEC-Q
15 TROUBLESHOOTING
Related buffer memory
address
Axis 1 Axis 2 Axis 3 Axis 4
Set range
(Setting with sequence program)
Remedy
Correct the end address (positioning address).
(Refer to Section 9.2.10)
Same as in error codes 525.
Correct the center point address (arc address).
(Refer to Section 9.2.11) Refer to Section 5.3
"List of positioning data"
Same as in error codes 504, 506.
Correct the positioning address.
(Refer to Section 9.2.16, 9.2.17, 9.2.18)
Refer to Section 5.3
"List of positioning data"
and Section 5.4
"Block start data"
—
In the error history, check the axis where the error
other than this error occurred, and remove the error
factor. Correct the block start data and positioning data.
— Normalize the block start data.
Refer to Section 5.4
"Block start data"
<Special start instruction>
00
H
to 06
H
Correct the special start instruction code.
(Refer to Section 5.4
Da.13
)
Refer to Section 5.3
"List of positioning data"
—
Correct the control system.
(Refer to Section 5.3
Da.2
)