Mitsubishi Melsec-Q QD75D1, User Manual

Page: 608 / 858

13 - 2
MELSEC-Q
13 COMMON FUNCTIONS
13.1 Outline of common functions
"Common functions" are executed according to the user's requirements, regardless of
the control system, etc. These common functions are executed by peripheral devices
or using sequence programs.
The following table shows the functions included in the "common functions".
Means
Common function Details
Sequence
program
Peripheral
devices
Parameter initialization
function
This function returns the
parameter stored in the QD75
buffer memory and flash ROM to
the factory-set initial value.
Execution data backup
function
This function writes the
"execution data", currently being
used for control, to the flash
ROM.
External I/O signal logic
switching function
This function switches I/O signal
logic according to the equipment
connected to the QD75.
For the system in which drive unit
READY with b-contact, upper
limit switch, and lower limit switch
are not used, the parameter logic
setting can be controlled without
wiring if it is changed to a
"positive logic".
External I/O signal
monitor function
This function monitors the
external I/O signal monitor
information in the module's
detailed information which can be
displayed on the system monitor
of GX Developer .
⎯ ⎯
For the QD75P /QD75D , this function is available in GX Developer (SW6D5C-GPPW-E or
later).
For the QD75P N/QD75D N, external I/O signals cannot be monitored on GX Developer.
Use the system monitor of GX Works2.