Fuji Electric FRENIC-AQUA series, User Manual

Page: 415 / 751

6-134
„ Pattern Operation Configuration Example
Function code Setting data Reference frequency
C21 (Mode selection) 1 --
C22 (Stage 1) 60.00 s FWD 2 C05 Multistep frequency 1
C23 (Stage 2) 100.00 s FWD 1 C06 Multistep frequency 2
C24 (Stage 3) 65.50 s REV 4 C07 Multistep frequency 3
C25 (Stage 4) 55.00 s REV 3 C08 Multistep frequency 4
C26 (Stage 5) 50.00 s FWD 2 C09 Multistep frequency 5
C27 (Stage 6) 72.00 s FWD 4 C10 Multistep frequency 6
C28 (Stage 7) 35.00 s FWD 2 C11 Multistep frequency 7
The above configuration example produces the operation shown in the chart below.
To start or stop a pattern operation, use the
/ keys on the keypad or turn the related
input terminals ON/OFF.
When using the keypad, for example, press the key to start a pattern operation. To stop the
current stage temporarily, press the key. Press the key again to start the pattern
operation from the stopped point of that stage.
Halfway through a pattern operation, to run the inverter from Stage 1 (C22), enter a stop
command and then press the
key.
If the inverter stops due to an alarm, press the key to cancel the inverter protective
function and then press the
key again. The stopped stage starts again.