Fuji Electric FRENIC-AQUA series, User Manual

Page: 570 / 751

6.3 Details of Function Codes
6-289
Chap. 6
FUNCTION C
ODES
J505 External PID Control 1 (Display unit)
J605 (External PID Control 2 (Display unit))
J655 (External PID Control 3 (Display unit))
J505, J605 or J655 selects a display unit for external PID control 1, 2 or 3, respectively.
Under external PID control, the external PID command setting value (SV), feedback value
(PV), manipulated value (MV) and others can be monitored on the keypad. For these values,
select the display units.
For the setting procedure of the monitor display, refer to Chapter 5, Section 5.5.1
"Monitoring the running status."
When external PID control is to be performed with the same unit and scale as for
feedback values, the J505/J605/J655 settings need not be changed. (Factory default:
In accordance with the unit and scale used for feedback values)
Configure the J505/J605/J655 to use different unit and scale from feedback values.
Data setting range: 0 (Inherit) to 80
Data for
J505/J605/
J655
Display unit
Data for
J505/J605/
J655
Display unit
Data for
J505/J605/
J655
Display unit
0: Inherit (Factory default)* 24 L/min (flowrate) 46 Psi (pressure)
1 No unit 25 L/h (flowrate) 47 mWG (pressure)
2 % 40 Pa (pressure) 48 inWG (pressure)
4 r/min
41 kPa (pressure) 60 K (temperature)
7 kW 42 MPa (pressure) 61
°
C (temperature)
20 m
3
/s (flowrate) 43 mbar (pressure) 62
°
F (temperature)
21 m
3
/min (flowrate) 44 bar (pressure) 80 ppm (density)
22 m
3
/h (flowrate) 45 mmHg (pressure)
*
In accordance with the unit and scale used for feedback values
For feedback value selection, see function codes E61 to E63.
The table below lists function codes to be used for setting a unit and scale for feedback
values.
Display unit Maximum scale Minimum scale
Terminal [12] C58 C59 C60
Terminal [C1] C64 C65 C66
Terminal [V2] C70 C71 C72