Fuji Electric FRENIC-AQUA series, User Manual

Page: 385 / 751

6-104
„
Switch to fire mode -- FMS (Function code data = 134)
Turning the FMS this terminal command ON switches to the fire mode to be used in an
emergency, in which the inverter runs the motor at the predetermined speed.
Refer to H116 through H121.
„
Switch pump control -- PCHG (Function code data = 149)
Turning the PCHG ON enables the pump control switching signal to switch the motor
regularly. This command is available only when J401 (Pump control mode selection) = any of
1 through 3 and 52.
Refer to J401.
„
Enable master motor drive in mutual operation -- MEN0 (Function code data = 150)
Turning the MEN0 ON enables the master motor to be driven in mutual operation. Turning it
OFF disables the master motor to stop it. If no MEN0 is assigned, the master motor is capable
of being driven.
Refer to J401.
„
Enable pump control motor 1 to 8 to be driven
-- MEN1 to MEN8 (Function code data = 151 to 158)
Turning the MEN1 to MEN8 ON enables the corresponding motors to be driven under pump
control. Turning them OFF prohibits the motors from being driven. If MEN1 to MEN8 are
not assigned, those motors are capable of being driven. In mutual operation, slave inverters 1
and 2 correspond to
MEN1 and MEN2 , respectively.
Refer to J401.
„
PID multistep command
-- PID-SS1 , PID-SS2 (Function code data = 171, 172)
Turning the PID-SS1 and PID-SS2 ON/OFF selectively switches the PID multistep
commands (preset by J136 through J138) in three steps. This command is available for both
PID control 1 and PID control 2.
Refer to J136 through J138.
„
External PID multistep command
-- EPID-SS1 , EPID-SS2 (Function code data = 181, 182)
Turning the EPID-SS1 and EPID-SS2 ON/OFF selectively switches the external PID
multistep commands (preset by J551 through J553) in three steps.
Refer to J550 through J553.
„
Cancel timer -- TMC (Function code data = 190)
Turning the TMC ON cancels timer operation.
Refer to T01 through T19.