Fuji Electric FRENIC-AQUA series, User Manual

Page: 51 / 751

2-16
Analog output, transistor output, and relay output terminals
Classifi- cation
Symbol Name Functions
[FM1]
[FM2]
Analog monitor These terminals output monitor signals of analog DC voltage (0
to +10 V) or analog DC current (+4 to +20 mA DC or 0 to +20
mA DC).
The output form (VO/IO) for [FM1] or [FM2] can be switched
by the slide switch (SW4/SW6) on the control PCB and the
function code F29/F32, as listed below.
Output form
Terminal Function
DC voltage DC current
Signal function
specified by
SW4 VO1 IO1
FM1
F29 0 1
F31 data
SW6 VO2 IO2
FM2
F32 0 1
F35 data
The signal function can be selected from the following with
function code F31/F35.
• Output frequency
• Output current • Output voltage
• Output torque • Load factor • Input power
• PID feedback amount • DC link bus voltage
• Universal AO • Motor output
• Calibration • PID command • PID output
• PID deviation • Reference frequency
• Customizable logic output signal
• Inverter heat sink temperature
• Reference frequency, etc.
For details, refer to Chapter 6 "FUNCTION CODES."
- Input impedance of external device: Min. 5k
Ω
(at 0 to 10 VDC
output)
(While the terminal is outputting 0 to 10 VDC, it is capable of
driving up to two analog voltmeters with 10 k
Ω
impedance.)
- Input impedance of external device: Max. 500
Ω
(at 4 to 20 mA
DC output)
- Adjustable range of the gain: 0 to 300%
Anal
og
o
ut
put
[11] Analog common Two common terminals for analog input and output signals.
These terminals are electrically isolated from terminals [CM]s
and [CMY].