Fuji Electric FRENIC-AQUA series, User Manual

Page: 541 / 751

6-260
Functions for different J401 operating formats
Some functions are disabled, depending on the J401 operating format. The chart below
indicates whether functions are enabled or disabled.
J401:
Pump control operation mode selection Function code
1 2 3 52 54
J101 to J138/J201 to J231 Y
Boost function (J143 to J147) Y N
Slow flow rate stop
(J149 to J154, J156 to J160/J249 to J251, J256 to
J260)
Y
Flow sensor input selection (J163 to J166) Y
High frequency operation protection (J168, J169) Y
Dry pump protection
(J176 to J180/J276 to J280)
Y N
End of curve protection (J182 to J186) Y N
Filter clogging/ anti-jam (J188 to J195) N
Communication master/slave selection (J402) N Y
Number of slave units (J403) N Y
Master input transmission selection (J404) N Y
Motors 1 to 8 drive selection
(J411 to J418)
Y N
Motor switching sequence (J425) Y N
Stop of commercial power-driven motors (J430) Y N
Motor fixed-period switch (J435 to J437) Y N
Motor increase judgment (J450, J451) Y N
Motor decrease judgment (J452, J453) Y N
Motor switching time contact wait period (J454) N Y N
Motor increase switching time (deceleration time)
(J455)
Y N N N
Motor increase switching level (J456) Y N N N
Motor increase PID control start frequency (J457) Y N N N
Motor decrease switching time (acceleration time)
(J458)
Y N N N
Motor decrease switching level (J459) Y N N N
Motor decrease PID control start frequency (J460) Y N N N
Motor increase/decrease judgment dead zone (J461) Y N
Abnormal unit judgment time (J462) N N N
Auxiliary motor (J465 to J467) Y
Auxiliary motor (J468, J469) N Y N
Y: Enabled, N: Disabled