Fuji Electric FRENIC-AQUA series, User Manual

Page: 573 / 751

6-292
„ I integral time (External PID control 1: J511, External PID control 2: J611,
External PID control 3: J661)
J511/J611/J661 specifies the integral time for the external PID processor.
- Data setting range: 0.0 to 3600.0 (s)
0.0 means that the integral component is ineffective.
„ D differential time (External PID control 1: J512, External PID control 2: J612,
External PID control 3: J662)
J512/J612/J662 specifies the differential time for the external PID processor.
- Data setting range: 0.00 to 600.00 (s)
0.00 means that the differential component is ineffective.
„ Feedback filter (External PID control 1: J513, External PID control 2: J613),
External PID control 3: J663)
J513/J613/J663 specifies the time constant of the filter for feedback signals under the external
PID control.
- Data setting range: 0.0 to 900.0 (s)
- This setting is used to stabilize the PID control loop. Setting too long a time constant makes
the system response slow.
J514 External PID Control 1 (Anti-reset wind-up)
J614 (External PID Control 2 (Anti-reset wind-up))
J664 (External PID Control 3 (Anti-reset wind-up))
J514, J614 or J664 suppresses overshoot under external PID control 1, 2 or 3 using an
external PID processor, respectively. As long as the deviation between the PID command and
its feedback is out of the preset range, the integrator holds its value and does not perform
integration operation.
- Data setting range: OFF, 0.01 to 9990.00 (The setting range is restricted by the maximum
scale and minimum scale.)