Fuji Electric FRENIC-AQUA series, User Manual

Page: 212 / 751

5.6 Programming Mode
5-33
Chap. 5
PR
EP
AR
A
T
IO
N AND
TEST
RUN
Table 5.12 Programming Mode Menus (Continued)
Main
Menu
Sub-Menu
Hierarchy
Display
Principal Functions
3. INV Info: Allows monitoring of inverter operational status.
1 Power monitor PRG>3>1 Allows monitoring of the estimated amount of power.
2
Operation
monitor
PRG>3>2 Displays operational information.
3 I/O check PRG>3>3 Displays external interface information.
4
Maintenance
information
PRG>3>4
Displays cumulative run time and other information
used during maintenance.
5 Unit information PRG>3>5
Allows confirmation of inverter type, serial number
and ROM number.
4. Alarm Info: Displays alarm information.
1 Alarm history PRG>4>1
Lists alarm history ( 9 previous). Detailed
information can be confirmed for the four most recent
occurrences.
2
Light alarm
history
PRG>4>2 Lists light alarm history ( 5 previous).
3 Retry history PRG>4>3 Displays retry history (two instances).
5. User Config: Allows any settings to be made.
1
Quick setup
selection
PRG>5>1
Allows function codes to be added to or deleted from
the "0. Quick Setup" display.
2 Password PRG>5>2
Allows setting to prevent inverter function code access
or data revision.
6. Tools: Various functions
1 PID monitor PRG>6>1
Allows status of PID controls 1 and 2 and external PID
controls 1, 2 and 3 to be monitored. (PV, SV, MV, etc.)
2
Unit number
control monitor
PRG>6>2
Allows confirmation of the operational status on the
pump number control.
3 CLogic monitor PRG>6>3 Previews and debugs customized logic.
4
Resonance
prevention
PRG>6>4
During operation, allows jump frequency to be set
while confirming resonance status.
5
Load Factor
Measurement
PRG>6>5
Allows measurement of the operational status of the
maximum output current and average output current.
6 Signal debug PRG>6>6
Allows monitoring and setting of
communication-specific function codes (S, M, W, W1,
W2, W3, X, X1, Z).
5.6.1 Quick Setup
PRG > 0(Quick Setup)
In programming mode, menu number 0, "Quick Setup" shows only those function codes
predetermined to have a high usage frequency.
Menu number 5, "User Config" can be used to add or delete function codes from the Quick Setup.
5.6.2 Start-up
PRG > 1(Start-up)
In programming mode, menu number 1, "Start-up" allows display of information needed on startup: the
language displayed on the LCD monitor, data and time settings, and inverter operational status.